Step
1
Auto Learn Standard Configuration (default)
The auto learn configuration will automatically setup the remote
button configuration. Note: Due to the Supercode protocol, you
cannot change the configuration.
2
Delete remotes: This feature will erase all remotes from the memory
of the system. This is useful in cases when a customer's remote is
lost or stolen. Note: Does not reset the programmed features of the
system or reset the Virtual Tach setting.
3
Reset Features: This resets all the features of the system to the fac-
tory default settings. Note: Does not delete the remotes from the
system or reset the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization. Note: The "Zap" feature on the Bitwriter
does not reset the Virtual tach setting.
Learn Routine is exited if:
•
The ignition is turned off
•
The program switch is pressed too many times
•
More than 30 seconds elapses between steps
38
3.Transmit. Press the
The horn honks to confirm that the code has been suc-
cessfully programmed. It is not possible to teach a
remote control button to the system more than once.
4. Advance. You can advance from one function step to
another by releasing the Valet/Program switch and tap-
ping it to advance function steps and then holding it.
Function
button on the remote control.
© 2008 Directed Electronics. All rights reserved.