Table of Contents
Advertisement
DFBC = digital fi replace burner control
1) Remove the faceplate and glass door to access to Receiver.
2) Remove the hi/lo knob from the valve head, if installed, by removing
2 screws as shown below.
3) Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.
4) Install 4 - AA batteries into the receiver, ensure correct polarity.
Regency Horizon HZ54EPV Gas Fireplace
GTM REMOTE INSTALLATION
5) Remove the module tray on the right side of the unit to access the DFBC
6) Plug receiver wires into the back of the receiver and bundle wires
7) Connect GTM motor wire from the stepper motor to the wire connector
8) Program Receiver and transmitter (refer to manual)
Note: DO NOT USE 4 AA batteries on the control module; the DFBC is now
with the wire clip as shown below.
from the receiver wire harness.
powered by the receiver batteries in the wall.
INSTALLATION
Wire Clip
37
Advertisement
Table of Contents
