Cabinet Door Alignment; Cabinet Door Removal - KitchenAid KBFU271 Installation Instructions And Use & Care Manual

3. Remove filter from its connection and discard. (Follow the
instructions provided with your refreshment center water filter
to replace. See "Assistance or Service" section to order.)
4. Disconnect ice bin and sink drain and plastic tubing from the
filter connector and allow to drain.
A. Plastic tubing
5. Cover refreshment center with accessory cover or tarpaulin.

Cabinet Door Alignment

Style 2 Only
Your cabinet door(s) can be realigned if necessary.
1. Check door to determine alignment requirements.
2. Open the cabinet door.
3. Locate and loosen the 4 door hinge mounting screws ½ turn.
A. Top screws (2 - underside of frame)
B. Bottom screws (2)
4. Adjust the top or bottom of the door in the direction
necessary to align the door.
5. Tighten the 4 door hinge mounting screws.
6. Close the door and check alignment.
7. Readjust the door using steps 2 through 6 if necessary.
8. Repeat steps 1 through 7 on the other door if necessary.
A
A
B

Cabinet Door Removal

The door(s) can be removed if necessary to gain access to the
inside of the cabinet area.
Style 1
To Remove the Door:
1. Open cabinet door.
2. Lift door to slide door hinge pins from hinge brackets on
cabinet.
A. Door hinge pin
B. Hinge bracket
3. Repeat steps 1 and 2 for the other door if necessary.
To Replace the Door:
1. Position hinge pins on the door with the hinge brackets on
the cabinet. Gently push down to slide the pins into place.
A. Door hinge pin
B. Hinge bracket
2. Repeat Step 1 for the other door if necessary.
A
B
A
B
9