Cabinet Cutout Dimensions - KitchenAid 740-0781K Installation Instructions And Use & Care Manual

Built-in outdoor grill

Table of Contents

Available languages

The illustration below includes cutout dimensions and minimum spacing requirements. The illustration is for reference. The design

of your cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed.

Center or support surfaces must be level.

The installation of this grill must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code,

ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.

Copies of the standards listed may be obtained from:

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

NOTE: The grill drops into the opening and is supported by its side flanges. Do not use a bottom support.

Built-in Outdoor Grill Enclosure Ventilation for LP Gas

Any enclosure is to be ventilated by openings at both the top

and lower levels of the enclosure. The following information is

the minimum for proper ventilation of your island construction.

◼

There should be a minimum of 1 7/8" (4.4 cm) of clearance

from the bottom of the main burner bowl assembly island

for proper ventilation.

NOTE: There should be no solid surface underneath the

firebox portion of the grill.

◼

A minimum of 3" (7.6 cm) is required between the back of

the grill and any noncombustible materials. A minimum of

36" (92 cm) is required between the back of the grill and

any combustible material.