Attach Condiment Shelf - KitchenAid KBFU271 Installation Instructions And Use & Care Manual

Style 2
To Remove the Door:
1. Open the door to the fully open position.
2. Locate and remove the 4 door hinge mounting screws.
A. Top screws (2 - underside of frame)
B. Bottom screws (2)
3. Pull the door away from the center to slide the door hinges
out of the slots in the frame.
4. Repeat steps 1 through 3 for the other door if necessary.
10
To Replace the Door:
1. Slide the door hinges into the slots in the frame and push in
to seat hinges.
A
2. Locate the 4 hinge screw mounting holes through the top and
bottom of the frame and replace the 4 screws. Do not tighten.
B
3. Check and adjust door then tighten the screws. See "Cabinet
Door Alignment."
4. Repeat steps 1 through 3 for the other door if necessary.
1. Open cabinet door.
2. Use a short Phillips screwdriver or a 90° screwdriver with a
Phillips screw bit to loosen the 2 mounting screws on the
inner door panel.
3. Position the condiment shelf so that the large ends of the
keyhole slots are over the 2 mounting screws.
4. Lower the condiment shelf until the 2 mounting screws are in
the narrow ends of the keyhole slots.
5. Tighten the screws.

Attach Condiment Shelf

A
A. Mounting screws
A
B
A. Mounting screw in keyhole slot
B. Condiment shelf