Table of Contents
Advertisement
Standalone Mode
The NPT710 and PX328 support a simple standalone mode.
Configure Standalone Mode
1. If using the internal NPT modem, ensure Dial-up parameters are set up.
2. Configure Standalone Mode options (Function 11112223), refer to table below.
3. Switch to Standalone Mode by pressing [Func] button then enter, followed by 11112222 then enter. The
terminal will prompt switch to standalone mode, press enter to accept.
Terminal display
FUNCTION
********
INTERNAL PRINT?
USE WINDOWS
DEFAULT PRINTER?
INTERNAL MODEM?
JOURNAL TXNS?
PRINT SECOND
RECEIPT?
SWIPE START
TRANSACTIONS?
Confidential
Comment
The merchant press [FUNC].
The merchant enters [1] [1] [1] [1] [2] [2] [2] [3] and press [ENTER].
Pressing [ENTER] will enable the terminal to use the internal printer. Pressing
[CLEAR] will allow the terminal to send receipts to the POS to be printed.
If the operator selected [ENTER] from above, this will prompt. Select [ENTER] if the
default Windows printer is to be used on the POS. Select [CLEAR] if the POS printer
is to be used for printing.
Pressing [ENTER] will enable the terminal to use the internal modem. Pressing
[CLEAR] will allow the terminal to use the POS to send messages to and from the
bank.
If both Internal Print and Internal modem were both selected, this option will be
displayed. It allows the terminal to journal the transactions to the EFT-Client on the
POS. It should only be selected if the POS will be connected and the Eft-client is
running.
Selecting [ENTER] will allow the standalone mode to prompt for the printing of a
customer receipt after the merchant receipt has been printed. Selecting [CLEAR] will
only print the customer copy of debit card receipts.
Selecting [ENTER] will allow the standalone mode to start a transaction by the
customer swiping a card or selecting the option from the menu, Selecting [CLEAR]
will only allow a transaction to be started by the menu.
Page 10
4/23/2008
Advertisement
Table of Contents
