Table of Contents
Advertisement
(3) GAIN LEVEL : Setting of electrical sensitivity
-LEVEL- : Adjust MANUAL gain level
0 (Factory setting) to 341 : Set MANUAL gain when AGC is OFF.
(4) BRIGHTNESS : Adjust offset level
0 to 255
: Set in 256 steps.
(5) GAMMA : Setting of gamma correction
-MODE- : Selection of mode
OFF (Factory setting)
ON
-LEVEL- : Adjust gamma correction
0 (Factory setting) to 255 : Set gamma curve in 256 steps.
(6) KNEE : Setting of KNEE
-MODE- : Selection of mode
OFF (Factory setting)
ON
-KNEE POINT- : Adjust knee point
0 (Factory setting) to 32 : Setting value toward 0 side increase start level of knee and 32 side decrease start level of
knee.
-KNEE SLOPE- : Adjust knee slope
0 (Factory setting) to 159 : Setting value toward 0 side intensify effective of knee and 159 side weaken effective of knee.
(7) LUT : Setting of Look Up Table
-MODE- : Selection of mode
OFF (Factory setting)
ON
-TABLE R [n]- : 256 LUTs for Red (n is table number and input)
0 to 255
-TABLE G [n]- : 256 LUTs for Green (n is table number and input)
0 to 255
-TABLE B [n]- : 256 LUTs for Blue (n is table number and input)
0 to 255
(8) SHARPNESS : Setting of object contour correction
-MODE- : Selection of mode
OFF (Factory setting)
ON
-LEVEL- : Adjust sharpness level
0 to 255
(9) ALC : Setting of Auto Level Control of video level
-MODE- : Selection of mode
OFF (Factory setting)
AGC
AES
AGC & AES
-VIDEO LEVEL- : Setting of video level when AGC or AES is ON
0 to 255
: Setting value toward 0 side decrease convergence level and 255 side increase convergence level.
(Factory setting:128)
Adjustable from 0 to 12dB in 342 steps.
(Factory setting:128)
: Not perform gamma correction.
: Adjust the detail gamma according to setting value.
*This function is enable when LUT MODE is OFF
: Not perform knee.
: Knee function provides natural gradation in bright portions.
* This function is enable when LUT MODE is OFF
: Not apply LUT for the image.
: The output image Adjusted LUT Knee function provides natural gradation in bright portions.
: Output to input (Factory setting is table number).
: Output to input (Factory setting is table number).
: Output to input (Factory setting is table number).
: Not perform contour correction.
: Perform contour correction according to setting value.
: Setting value toward 0 side reduces correction for soft contours and 255 side increase
correction for sharper contours (Factory setting: 128).
: AGC is set to OFF (MANUAL gain). AES is set to OFF (NORMAL shutter).
: AES is set to OFF and video level is automatically adjusted in the range of 0 to 12dB.
: Shutter is automatically adjusted to light source brightness.
: Both AGC and AES are set to ON.
6
Advertisement
Table of Contents
