Learning Edid; Learning Edid To All Inputs - Binary B-100-HDMATRIX-4X4 Owner's Manual

B-100 HDMATRIX Installation and Users Manual 4X4 & 8X8

4.2.2 Learning EDID

For more advanced EDID configuration, learning can be used to assign EDIDs. When used
,the EDID from a particular display is assigned to a particular source or all sources. This
is useful when the system contains a display that may not output the highest resolution
available from the sources.
When to Use Learned EDIDs
• An older display does not work properly with any of the embedded EDIDS.
• When the source is a PC, it may be necessary to use a learned EDID.
• Learning EDID to a Single Input.
Example: Input =1 EDID Learned from Output 4
1. Press LEARN
2. Press OUTPUT
3. Press Number key (1-8) to select the Output the
EDID is learned from
4. Press INPUT
5. Press Number Key (1-8) to select the Input to
which the EDID is applied
6. Press ENTER

4.2.2.1 Learning EDID to All Inputs

Note that learning the EDID for a display to all sources is the same as using Auto EDID.
Example: Input=All EDID Learned from Output 4
1. Press LEARN
2. Press OUTPUT
3. Press Number Key (1-8) to select the Output the
EDID is learned from
4. Press ENTER
pg.14
Display Readout (Example)
L -
. .
1A
14
L-
1A
--
(success)
FF
(fail)
Display Readout (Example)
L -
. .
4
(success)
--
FF (fail)