Table of Contents
Advertisement
When to Use Learned EDIDs
•
An older display does not work properly with any of the embedded EDIDs.
•
When the source is a PC it may be necessary to use a learned EDID.
•
Learning EDID to a single input
7.5.1. How to Learn EDID to a Single Input
Example: Input =1 EDID Learned from Output 4
1. Press LEARN once for HDMI port or twice for HDBaseT port
2. Press OUTPUT
3. Press Number key (1-8) to select the Output the EDID is learned from
4. Press INPUT
5. Press Number Key (1-8) to select the Input to which the EDID is applied
6. Press ENTER
7.5.2. How to Learn EDID to All Input
Example: Input=All EDID Learned from Output 4
1. Press LEARN
2. Press OUTPUT
3. Press Number Key (1-8) to select the Output the EDID is learned from
4. Press ENTER
7.6. Viewing Input EDID Status
If there is a question about the EDID set for an input, the status of that input's EDID can be reviewed using the
included IR remote and watching the matrix switcher front panel display.
Example: View the EDID for Input 3.
1. Press STATUS
2. Press INPUT
3. Press Number Key (1-8)to select the desired
Input
4. Press ENTER
Notes about EDID Status
•
If the EDID was learned from an output, the exact EDID specifications will not be shown, but the output
number will be identified. Review the specifications of the display attached to the output to determine its
compatible resolutions.
•
If the second digit (the Input being queried) has a dot after it, then the first digit is the EDID number from the
Embedded EDID table.
•
If the second digit (the Input being queried) does not have a dot after it, the first digit is the output the EDID
was learned from (step 4 from example above).
Display Readout (Example)
L.-.
1A
14
L-
1A
--(success)
FF (fail)
Display Readout (Example)
EDID 5 Assigned from
Embedded EDID Table
--
--
-3
5.3.
23
Display Readout (Example)
L.-.
L-
4
--(success)
FF (fail)
EDID Learned from
Output 4
--
--
-3
4.3
Advertisement
Table of Contents
