Table of Contents
Advertisement
The Schedule tab on the Archiving page allows you to select the types of data and devices to archive:
1
3
On the Days tab, you can configure archiving of all data, motion video (which includes alarm video), or just alarm
video. To change the Setting, complete the following steps:
1. Select the appropriate tab for the day of the week.
2. In the grid, draw a rectangle that corresponds to the hours for each device that you want to configure.
3. When you hover the cursor over a square, note the details displayed in the Information section.
NOTE: The Record Setting and the Archiving Setting do not have to be configured for the same type of
data. For example, you could record Free Run video on a system at a certain time, but then archive only
the motion video recorded during that period. However, if only motion/alarm video was recorded, the All
setting on the archive page will cause only motion/alarm video to be archived. The amount of video
available for archiving cannot exceed the amount of video recorded during that period.
4. Select the appropriate Setting button.
5. To copy the schedule from one day of the week to another, select the appropriate days of the week in the
Copy Current Configuration section, and then click Set.
6. Click Apply.
www.exacq.com
52
4
2
5
+1.317.845.5710
USA (Corporate Headquarters)
+5255.56080817
Mexico
+44.1438.310163
Europe/Middle East/Asia
6
Advertisement
Table of Contents
