Table of Contents
Advertisement
PTZ presets can be configured by clicking the left Presets button on the Camera Settings page.
5
4
3
1
2
10
1. Use the Pan/Tilt buttons to point the camera at the desired preset location. If the camera moves too
quickly or too slowly, move the Speed slider left (slower) or right (faster).
2. Adjust the Zoom, Focus, and Iris settings as desired (Focus and Iris are not available when configuring IP
cameras).
3. Enter a name or number for the preset in the Name field.
4. Click New to enable the preset.
5. The preset is listed under Presets. The total number of presets configured and supported is shown under
the list.
6. To create a Preset tour, select a preset from the Presets list and click Add>> to show it in the Preset Tour
list. Repeat for each remaining preset that you want to include in the tour. You can re-order the presets in
the Preset Tour list by clicking and dragging them to the desired place in the tour. To delete a preset from
the tour, select it in the Preset Tour list and click <<Remove. A preset can be included multiple times in
the tour.
7. Resume time is the number of seconds that certain PTZ functions (such as a tour, a linked event, or a soft
trigger) can resume after a user manually controls PTZ functions. Dwell time is the amount of time that
the camera stays on each preset.
8. Select Enable to activate the tour.
9. Select Apply to complete the process.
10. The Open button displays the camera manufacturer's onscreen menu. Actions required to accept
onscreen information vary by manufacturer; clicking Iris Open and Focus Far are the most common.
6
9
11
www.exacq.com
34
8
7
+1.317.845.5710
USA (Corporate Headquarters)
+5255.56080817
Mexico
+44.1438.310163
Europe/Middle East/Asia
Advertisement
Table of Contents
