Battery Information - Polycom KIRK 6020 User Manual

Polycom Kirk 6020-6040 User Guide

Battery Information

8
The battery is connected to the handset from factory and must not be removed.
To replace the battery, please contact your local distributor.
Charging Battery
When charging battery for the first time, it is necessary to leave handset in
charger for 14-16 hours for the battery to be fully charged.
During normal operation, it takes approximately 6 hours to charge the handset
from fully discharged to its full capacity. Turning the backlight off reduces
charging time with approximately 2 hours (refer to
page 54).
Place handset in charger.
For correct charging, be sure the room temperature is between 0°C and 40°C.
Do not place the handset in direct sunlight. The battery has a built-in heat
sensor which will stop charging if the battery temperature is too high.
If the handset is turned off when placed in charger, nothing indicates the
charging. There will be no reaction on incoming calls.
If the handset is turned on when charging, the display shows the blue charging
icon in the status bar. The charging icon is replaced by the green fully
charged icon , when the battery is fully charged (when handset is removed
from charger, the charging icon disappears). The handset will not vibrate. Auto
answer is inactive. The handset reacts normally for incoming calls.
It is necessary to recharge battery when display shows the battery low icon
or if the handset cannot be turned on.
Battery Information
"Turning Backlight Off" on
Polycom, Inc.
,