Capture Memory Locations - Johannus Ecclesia T-250 User Manual

Calling up a pre-programmed memory location:
Press a pre-programmed memory location (PP-T). The active stops light up.
Programming a pre-programmed memory location:
The current setting of the pre-programmed memory location will be lost.
Although it is possible to store any registration under a piston of a pre-
programmed memory location it is advisable to select a registration matching the
text of the piston.
1. Select the desired stops.
2. Press the SET piston. Hold in the piston.
3. Press the desired pre-programmed memory location (PP-T).
4. Release the SET piston.
4.8.2

Capture memory locations

Through use of the capture memory, a registration can be activated with just one
piston. The capture memory consists of 250 levels.
These levels can be seen on the display (Mem:...). Each level has eight memory
locations (pistons 1-8). The 2000 capture memory locations are not pre-
programmed and can be programmed by the musician.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1. Select the desired stops.
2. Use the - and + pistons to select a level (1-250) on the display.
3. Press the SET piston. Hold in the piston.
4. Press the desired memory location (1-8).
5. Release the SET piston.
Calling up a capture memory location:
1. Use the - and + pistons to select the desired level (1-250) on the display.
2. Press the desired memory location (1-8). The active stops light up.
Through use of the SEQ- and SEQ+ pistons previous or next memory locations can
be selected in steps of one. The lighted memory location piston and the memory
level shown in the display indicate the selected location.
User Manual Ecclesia T-250 / D-350 / D-450 20