Capture Memory Locations; Memory Lock; Transposer - Johannus Ecclesia Choir User Manual

4.8.2

Capture memory locations:

Through use of the capture memory, a registration can be made active with just
one piston.
The capture memory consists of 250 levels.
These levels can be seen on the display
(Mem:...). Each level has eight memory
locations (pistons 1-8). The 2000 capture
memory locations are not pre-programmed and can be programmed by the
musician.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1. Select the desired stops.
2. Use the - and + pistons to select a level (1-250) on the display.
3. Press the SET piston. The piston lights up. Hold in the piston.
4. Press the desired memory location (1-8).
5. Release the SET piston.
If the SET piston does not light up when pressed, programming of a memory
location is locked. See § 4.8.3 Memory lock
Calling up a capture memory location:
1. Use the - and + pistons to select the desired level (1-250) on the display.
2. Press the desired memory location (1-8). The active stops light up.
Through use of the SEQ- and SEQ+ pistons previous or next memory locations can
be selected in steps of one. The lighted memory location piston and the memory
level shown in the display indicate the selected location.
4.8.3

Memory lock

The memory can be secured through a key switch. By turning the key a quarter to
the right, the security of the memory is removed. In this position, the key can not
be taken out of the lock.
Turn the key a quarter to the left to avoid unwanted overwriting of the memory.
Optionally the key can be taken out of the lock.
4.9

Transposer

The Transposer function shifts the pitch by half-tone increments (from -8 to +8).
The transposer setting can be read on the display
(Tr: ...).
1. Press the TRANS piston.
2. Use the - and + pistons to set the pitch.
User Manual Ecclesia Choir / Ecclesia T-150
Mem: 1 Vol:25
Tr: 0/440 Cr:--
Mem: 1 Vol:25
Tr: 0/440 Cr:--
14