Table of Contents
Advertisement
Copyright
Copyright © 2012 by PLANET Technology Corp. All right s reserved. No p art of this p ublication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form o r by any me ans, electronic, mechanical, magnetic, optical, chemical, manual or
otherwise, without the prior written permission of PLANET.
PLANET makes no representations or warra nties, either expressed or implied, with re spect to the co ntents
hereof and specifically disclaims any warranties, merchantability or fitness for any p articular purpose. Any
software described in this manual is sold or licen sed "as is". Should the programs prove defective following
their purchase, the buyer (and not PL ANET, its distributor, or its dealer) assumes the entire cost o f all
necessary servicing, repair, and any incidental or consequential damages resulting from a ny defect in the
software. Further, PLANET reserves the right to revise this publication and to make changes from time to time
in the contents hereof without obligation to notify any person of such revision or changes.
All brand and product names men tioned in this manual are trademarks and/or registered
trademarks of their respective holders.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limit s for a Cl ass B digital device, pursuant to
Part 15 of
FCC Rules. These limit s are de signed to provide reasonable protection against harmful
interference in a re sidential installation. This eq uipment generates, uses, and can radiate radio f requency
energy and, if not inst alled and used in acco rdance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee t hat interference will not occu r in a p articular
installation. If this equipm ent does cause harmful interference to radio or television receptio n, which can be
determined by turning the equip ment off and on, the use r is encouraged to try to corre ct the interference by
one or more of the following measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.
Consult the dealer or an experienced radio technician for help.
FCC Caution
To assure continued compliance. (example use only shielded interface cables when connecting to computer
or peripheral devices). Any changes or modification s not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: ( 1 )
This device may not cause harmful interference, and ( 2 ) this Device must accept any interference received,
including interference that may cause undesired operation.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC rad iation exposure set forth for an uncontro lled environment. In order
to avoid the possibility of excee ding the FCC radi o frequency exposure limits, human p roximity to the
antenna shall not be less than 20 cm (8 inches) during normal operation.
Safety
This equipment is designed with the utmost care for the safety of those who install and use it. However,
special attention must be paid to th e dangers of ele ctric shock and static electricity when working with
electrical equipment. All guidelines of this a nd of the computer manufacture must therefore be allowed at
all times to ensure the safe use of the equipment
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
.
2
Advertisement
Table of Contents
