PDF (Trace & Smooth) Settings
When outlining documents that are to be sent, you can change the recognition rate
of line drawings of the original.
NOTE
•
This mode is available only if the optional Universal Send PDF Advanced Feature Set
(standard-equipped for the Color imageRUNNER C3480i/C3080i) is activated.
•
If the optional Super G3 FAX Board or Super G3 Multi-Line FAX Board is installed and
you are sending documents by fax, this setting is disabled.
1
2
9
9-26
PDF (Trace & Smooth) Settings
(Additional Functions) ➞ [Communications Settings]
Press
➞ [TX Settings] under <Common Settings> ➞ [PDF (Trace &
Smooth) Settings].
Specify each setting ➞ press [OK].
<Outline Graphics>:
[On]:
Outlining of the graphics is performed.
[Off]:
Outlining of the graphics is not performed.
<Graphics Recognition Level>
[Normal]:
Sets a standard recognition level. (The data size becomes small.)
[Moderate]: The recognition level and data size are in between those of
[Normal] and [High].
[High]:
Sets the highest recognition level. (The data size becomes large.)