Canon Color imageRUNNER C3480 Sending And Facsimile Manual Sending And Facsimile Manual page 410

# 702
Cause
Remedy 1 Wait a few moments, and then try again after the other send jobs complete.
Remedy 2 Do not send the document to too many recipients at the same time. Send the
# 703
Cause
Remedy 1 Wait a few moments, and then try again after the other send jobs are complete.
Remedy 2 Erase documents stored in inboxes. If the machine still does not operate
# 704
Cause
Remedy
# 705
Cause
Remedy
13
13-18
Error Messages
The document could not be sent because the memory is full.
document to a smaller number of recipients.
The memory for the image data is full.
normally, turn the main power OFF, and then back ON. (See Chapter 1, "Before
You Start Using This Machine," in the Reference Guide.)
An error occurred while reading address information from the Address Book.
Check the address settings. If the machine still does not operate normally, turn
the main power OFF, and then back ON. (See Chapter 1, "Before You Start
Using This Machine," in the Reference Guide.)
The send operation was interrupted because the size of the image data is larger
than the Maximum Data Size for Sending set in E-mail/I-Fax Common Settings
in Communications Settings in System Settings (from the Additional Functions
screen).
Change the Maximum Data Size for Sending setting in E-mail/I-Fax Common
Settings in Communications Settings in System Settings (from the Additional
Functions screen). Select a lower resolution, or if you are using I-fax, decrease
the number of pages containing images that you are sending each time, so that
you do not exceed the Maximum Data Size for Sending limit. (See "E-Mail/I-Fax
Common Settings," on p. 11-5.) Depending on the destination conditions, it may
be possible to divide the data.