Care And Mainenance; Charging A Very Cold Battery; Specifications - Black & Decker BBC10 Instruction Manual

F04 appears when charging time exceeds 18 hours.
You may be using a charge current rate too low for a large battery. Select higher charge rate to charge the battery.
F F 0 0 5 5 — — O O v v e e r r h h e e a a t t e e d d C C o o n n d d i i t t i i o o n n
The ventilation grill that prevents the air from flowing in and out of the charger may be blocked.
• Follow the steps outlined in "Important Safety Instructions" at the front of this manual to disconnect AC cord and
clamps, allow the unit to cool for 30 minutes and reconnect.
• Make sure there is ample ventilation before resuming operation.
C C h h a a r r g g i i n n g g a a V V e e r r y y C C o o l l d d B B a a t t t t e e r r y y
If the battery to be charged is very cold (in temperatures below freezing — 0°C/ 32°F), it cannot accept a high rate of
charge. The initial charge rate will be low. The charge rate will increase as the battery warms. Never attempt to charge
a frozen battery.
With proper care and minimal maintenance, the 10 Amp Smart™ Battery Charger will provide years of dependable
service. For maximum performance, manufacturer recommends:
• After each use, clean the battery charger clamps — be sure to remove any battery fluid that will cause corrosion of
the copper clamps.
• Clean the outside case of the charger with a soft cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the charger. Do not operate when charger is wet.
• Keep the charger cords loosely coiled during storage to prevent damage to the cords.
W W A A R R N N I I N N G G S S : :
• Do not use charger if cords or clamps have been damaged in any way — call the Authorized Service Center nearest
you.
• There are no user-serviceable parts in this unit.
• Do not open the unit. In the event of malfunction, it must be returned to manufacturer for professional testing and
repair. Opening the unit will void the manufacturer's warranty.
W W A A R R N N I I N N G G : : The use of any accessory not recommended for use with this tool could be hazardous.
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable
power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black
& Decker location nearest you.

SPECIFICATIONS

Input: 120 or 220 volts AC, 50 or 60 Hz, 180W
Output: 12 volts DC, 2/6/10 amps continuous
CARE AND MAINTENANCE
SERVICE INFORMATION
Printed in China
188170-00
8/17/07
27