General Description - Speck pumps Badu EcoM3V Installation, Operating And Service Manual

Variable speed pool pump
Table of Contents

Advertisement

Important Safety Instructions
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS
WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
WARNING: Risk of Electrical Shock. Connect only to a grounding type receptacle protected by a ground-
fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the receptacle is
protected by a GFCI.
The unit must be connected only to a supply circuit that is protected by a ground-fault circuit-interrupter
(GFCI). Such a GFCI should be provided by the installer and should be tested on a routine basis. To test
the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be
restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to
the pump without the test button being pushed, a ground current is flowing, indicating the possibility of an
electric shock. Do not use this pump. Disconnect the pump and have the problem corrected by a qualified
service representative before using.
CAUTION: This pump is for use with permanently installed pools and may also be used with hot tubs
and spas if so marked. Do not use with storable pools. A permanently installed pool is constructed in or
on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is
constructed so that it may be readily disassembled for storage and reassembled to its original integrity.
TO REDUCE THE RISK OF ELECTRICAL SHOCK, connect ground wires to grounding screw located in
the motor. Use no smaller than a #12 AWG (3.3mm2) wire.
TO REDUCE THE RISK OF ELECTRICAL SHOCK, a bonding connector is provided for bonding to
metal water pipes, metal rails, or other metal within 5 feet of the swimming pool. All local points should be
bonded with a #8 AWG (8.4mm2) wire.
2

General Description

Badu EcoM3 - Variable Speed
The Badu EcoM3 - Variable Speed swimming pool pump is both environment friendly and cost efficient.
This revolutionary three speed pump provides the pool owner a simple three button control to operate
the pump, greatly reducing the operating cost at a reasonable investment. The robust pump is based on
Speck Pumps energy efficient design platform. The Badu EcoM3 - Variable Speed high performance,
medium head pump uses a state of the art axial flux permanent magnet brushless-DC motor controlled
by advance logic electronics. Providing cooler and quieter operation at a fraction of the cost of a standard
PSC motor.
6
SAVE THESE INSTRUCTIONS.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents