Service And Maintenance; Routine Maintenance - Speck pumps Badu EcoM3V Installation, Operating And Service Manual

Adjusting the Speeds - continued
To Adjust the HIGH Speed
• Verify that the pump is powered ON and the green power LED light is on.
• Press the HIGH button for 5 to 10 seconds, this will switch the control from Normal Operation Mode
to the Speed Adjust Mode. The HIGH LED light will begin to blink.
• Press the left (LOW) button to decrease the speed.
or
• Press the right (HIGH) button to increase the speed
(NOTE: The button will increase or decrease in increments of 200 RPM, in most cases. The
Speed Range for HIGH Speed is 2850, 3050, 3250, 3450. Factory Preset is 3450.)
• Press the middle (MED) button to save the current the speed and return to Normal Operation Mode.
• To Stop or Exit out of Speed Adjust Mode, Press the STOP button or wait 30 seconds without pressing
any buttons. NOTE: If the power is shut off or the pump is stopped using the stop button, upon
powering up the pump will run a two (2) minute prime on HIGH and then resume normal operation.
DO NOT press any buttons during prime operation.
Adjusting Back to Factory Settings
• Verify that the pump is powered ON and the green power LED light is on.
• Press and Hold all three (3) speed buttons (LOW, MED, and HIGH) for 5 to 10 seconds.
• All LED light will be fully lit. The LED's will blink to indicate the factory defaults were re-established.
5

Service and Maintenance

Routine Maintenance

This pump requires little or no service other than reasonable care and periodic cleaning of the strainer
basket.
1. Inspect the pump basket for debris by looking through the clear pump lid.
2. Turn off the power to the pump. If the pump is located below the water level, close isolation valves on
the suction and discharge sides of the pump to prevent back flow of water.
3. Remove any debris, because as the debris accumulates, it will begin to block the flow of water
through the pump. Keep the basket clean and clear to improve the performance of the pump.
4. Turn the lid's lock ring counter clockwise until it stops. Carefully remove the lid and lock ring.
5. Remove the basket and properly dispose of the debris into the trash and rinse out the basket. Check
basket for cracks, if crack is found replace basket.
6. Replace basket back into the pump, align the basket properly with the suction pipe. Then fill with
water up to the suction pipe. Clean clear cover, lid o-ring and sealing surface of the pump of any debris.
7. Replace lid with locking ring. Hand-tighten the lid to make an air-tight seal. Do not use any tools to
tighten the lid.
15