General Installation Instructions; Basic Motor/Timer Operation - Speck pumps BADU ECOM2/S90 Installation, Operating And Service Manual

M017837080000 REV. January 19, 2011

General Installation Instructions

Follow these instructions to prolong the life of your
swimming pool pump motor/control.
a. Protection against Heat
• Shade the motor/control from the sun.
• Provide ample cross ventilation.
• Protect the motor/control from lint, etc.,
that can plug the ventilation openings.
b. Protection against Dirt
• Keep motor/control and surrounding area clean.
• Avoid sweeping or stirring dust near the motor/
control while it is running.
• Avoid storing or spilling dry chemicals near
the motor/control.
c. Protection against Moisture
• Shade the motor/control from rain, snow, etc.
• Do not wrap motor/control with plastic or other
air tight materials.
• Locate motor/control on a slight elevation so water
will not run or puddle nearby.
• Avoid splashing water on or near the motor/control.
• Contact qualified service person to repair leaky
pipe joints or pump seals promptly.
6 2EZ Speed Pool Motor with Programmable Control/Timer
TM

Basic Motor/Timer operation

WARNING
!
A properly un tionin motor may
e too hot to tou h and ause in ury Be careful when
touching the exterior of an operating motor! This condition
is normal for most motors when operated at rated load
and voltage.
Your 2EZ Speed motor/timer has been fully tested for
TM
pool pump use before shipment. It is designed to be a
drop-in replacement for a standard single or two-speed
pool pump motor with only minor programming required.
To operate the motor control/timer, the installer must first
set the time of day and the day of the week. Please see the
specific sections of this manual for additional information.
Visually re-inspect the installation. Make sure that guards
and other protective devices are securely in place.
All covers and gaskets must be re-installed to minimize
the entry of dirt and moisture.