Product Specifications - Speck pumps Badu EcoM3V Installation, Operating And Service Manual

Motor Replacement - continued
7. After removal of the impeller, the seal housing will slide easily off the motor shaft.
8. Using a M8 Allen wrench, remove the four bolts and washers securing the flange to the motor.
9. Remove the slinger from the old motor and install on to the new motor.
10. Clean the surfaces of the seal (Refer to the
Mechanical Seal Section page 17 steps 9 -17).
7

Product Specifications

PART NUMBER DRAWING NUMBER
2921116010 160.1
2921116020 160.2
2901141201 412.1
2901114300 143
2921110108 101
2901158200 582
2920889410 894.1
2920889420 595
2991000088 914.1
2920141210 412.5
2921117412 174.2
20
25
QTY DESCRIPTION
1 LID
1 LOCK RING - LID
1 O-RING - LID 137 x 5mm
1 BASKET - ONE PIECE
1 CASING
1 CAP - DRAIN (3/8") WITH GASKET - CASING
2 LEGO SPACER
1 GASKET - (1/4" x 7/16" x 1")
8 SCREW - CASING HEX/SLOT M7 x 48mm SS
1 O-RING - DIFFUSER 90 x 5mm
1 DIFFUSER
Removal and Replacement of the Impeller and/or
PART NUMBER DRAWING NUMBER
230
2920723101
2920143310 433
2921141222 412.2
2921116125 161.2
2921111300 113
5879120825 914.2
2991000062 554.2
2500300902 721
2921770001 721.1
2500300914 721 & 721.1
2921157700 25
2921150700 507
QTY DESCRIPTION
1 IMPELLER (II) 1.0 HP S.F. 1.0
1 MECHANICAL SEAL (14mm)
1 O-RING - CASING 190 x 6mm
1 SEAL HOUSING 14mm
1 FLANGE
4 BOLT - FLANGE M8 x 25mm
4 WASHER - FLANGE BOLT (M8)
1 SET - DISCHARGE UNION COMPLETE
1 SET - SUCTION UNION COMPLETE
1 COMPLETE UNION SET - SUCTION/DISCHARGE
1 SPANNER - LID (OPTIONAL)
1 SLINGER - SPLASH RING
101 / 9.0mm M10