Additional Components Required; Tools, Lubricants, Adhesives; Inside The Main Box - SAB Heli Division Goblin 700 Manual

ADDITIONAL COMPONENTS REQUIRED

•Electric Motor:
10S-12S – 400-600Kv
Maximum diameter 64mm,
Maximum height 64mm, pinion shaft diameter 6mm
•Speed controller:
minimum 120A to be safe
•Batteries: 10-12S 4000-5000mAh
•1 flybarless 3 axis control unit
•Radio power system, if not integrated with the ESC.
•3 cyclic servos
•1 tail rotor servo
•6 channel radio control system on 2.4 GHz
(See the configuration example on page 28)
Inside the main box there are:

Inside the main box:

Box 2: Canopy, Blade Holder.
Box 3: Boom, Blades, Tail blades, Carbon rod.
Box 4: Mechanical parts in 4 trays:
Tray 1: Main rotor
Tray 2: Carbon frame and tail rotor
Tray 3: Transmission
Tray 4: Main structure
Box 5: Bags
Box 6: Carbon parts
Box 7: Combo Kit (optional)
Copyright@2012 – SAB Heli Division – All rights reserved
Chapter 3, Components and Box

TOOLS, LUBRICANTS, ADHESIVES

•Generic pliers
•Hexagonal driver, size 1.5,2,2.5,3,4mm
•4mm T-Wrench
•5.5mm Socket wrench (for M3 nuts)
•8mm Hex fork wrench (for M5 nuts)
•Medium threadlocker (eg. Loctite 243)
•Strong retaining compound (eg. Loctite 648)
•Spray lubricant (eg. Try-Flow Oil)
•Synthetic grease (eg. Tri-Flow Synthetic Grease)
•WD40 Lubricant
•Cyanoacrylate adhesive
•Pitch Gauge (for set-up)
•Soldering equipment (for motor wiring)
is described in the following chapters
The assembly process
of this manual.
Each phase begins with a green frame which gives the
box, the bag with screws (and miscellaneous items), and
the foam tray with the components required for the
phase.
Page 3