Important Notes; Safety Guidelines; Notes For Assembly - SAB Heli Division Goblin 700 Manual

IMPORTANT NOTES

•This radio controlled helicopter is not a toy.
•This radio controlled helicopter can be very dangerous.
•This radio controlled helicopter is a technically complex device which has to be built and handled very carefully.
•This radio controlled helicopter must be built following these instructions. This manual provides the necessary information to
correctly assemble the model. It is necessary to carefully follow all the instructions.
•Inexperienced pilots must be monitored by expert pilots.
•All operators must wear safety glasses and take appropriate safety precautions.
•A radio controlled helicopter must only be used in open spaces without obstacles, and far enough from people to minimize the
possibility of accidents or of injury to property or persons.
•A radio controlled helicopter can behave in an unexpected manner, causing loss of control of the model, making it very
dangerous.
•Lack of care with assembly or maintenance can result in an unreliable and dangerous model.
•Neither SAB Heli Division nor its agents have any control over the assembly, maintenance and use of this product. Therefore,
no responsibility can be traced back to the manufacturer. You hereby agree to release SAB Heli Division from any
responsibility or liability arising from the use of this product.

SAFETY GUIDELINES

•Fly only in areas dedicated to the use of model helicopters.
•Follow all control procedures for the radio frequency system.
•It is necessary that you know your radio system well. Check all functions of the transmitter before every flight.
•The blades of the model rotate at a very high speed; be aware of the danger they pose and the damage they may cause.
•Never fly in the vicinity of other people.

NOTES FOR ASSEMBLY

Please refer to this manual for assembly instructions for this model.
Follow the order of assembly indicated. The instructions are divided into chapters, which are structured in a way that each step
is based on the work done in the previous step. Changing the order of assembly may result in additional or unnecessary steps.
Use thread lockers and retaining compounds as indicated. In general, each bolt or screw that engages with a metal part requires
thread lock.
Factory pre-assembled components have been assembled with all the required thread lock and lubricants, and have passed
quality control. It is not necessary to disassemble and re-assemble them.
It is necessary to pay attention to the symbols listed below:
(eg Loctite 243)
Copyright@2012 – SAB Heli Division – All rights reserved
Important
Use medium
thread lock
Use retaining
compound
(eg Loctite 648)
Box xx
Use grease
Bag xx
(eg Tri-Flow
Synthetic Grease)
Tray xx
Chapter 2, Important notes
Use CA Glue
Indicates that for this
assembly phase you need
materials that are in
box xx, bag xx, tray xx.
Page 2