De-Burr The Side Frames; Esc Installation - SAB Heli Division Goblin 700 Manual

DE-BURR THE SIDE FRAMES

We recommend de-burring the edges of the carbon parts in areas where electrical wires run.

ESC INSTALLATION

The electronic speed control (ESC) is installed in the front part of the helicopter. The support is made of aluminum, which further
acts as a heat sink for the ESC. The figures below show the installation of three different brands of ESC.
Figure 4: Shows the wiring which connects the receiver and ESC (in this picture one frame has been removed). If the BEC system
used is combined with the ESC, it is recommended to use a dual wire connection.
Figure 5: The passage of the controller wires to the motor is highlighted. Figure 6: Shows the installation of a 2S battery for the
flight control system. Alternatively, a BEC could be placed in the same area.
Copyright@2012 – SAB Heli Division – All rights reserved
Chapter 10, Installation of the ESC
Fig. 4
2S Battery or BEC
ESC cables
Fig. 5
Fig. 6
Page 26