Installation Of Swashplate Servos; Assembly Of The Ball On The Horn - SAB Heli Division Goblin 700 Manual

INSTALLATION OF SWASHPLATE SERVOS

The size of the servo arms must be between 16-18 mm (figure 1). The 120° placement of the servos inside Goblin means the
arms are difficult to access. For this reason it is advisable to ensure alignment of the horns before installation of the servos in the
model (figure 2). Proceed with installation following the instructions below. Figure 3 shows a completed installation.
16/18 mm
Copyright@2012 – SAB Heli Division – All rights reserved
Fig. 1 Fig. 2
Fig. 4

Assembly of the ball on the horn.

The rods going from the servos to the swash plate must be as vertical as
possible. Not all servos are equal, so to better align them you can choose to
use the supplied spacer H0031. Figure 4 illustrates this.
Chapter 9, Installation of swashplate servos
Use thread lock on
the 12 M2.5 screws
Fig. 3
Bag 13
Bag 13
Pag. 24