SAB Heli Division Goblin 700 Manual page 27

The wire for the front servo must
go into this passage.
Tool HA002 (Bag14)
To tighten the horn screw, if
necessary, use the supplied
hexagonal wrench HA002.
Initial length for the rods from the servos to the swash plate
Copyright@2012 – SAB Heli Division – All rights reserved
Plastic ball link (H0066-S)
M2.5x18 (HC140-S)
Bag 13
Plastic ball link (H0066-S)
Chapter 9, Installation of swashplate servos
Fig. 5
Initial length for the rods from the swash plate to the blade
.
grips.
Fig. 6
Page 25