Installation Of The Motor; Motor Belt Tension - SAB Heli Division Goblin 700 Manual

Chapter 12, Installation of the motor

MOTOR BELT TENSION

•Assemble the motor and pinion to its mounting plate.
•Fit the motor assembly into position.
•Compress the springs by pushing the motor toward the main shaft.
•At maximum compression, temporarily tighten one of the slide screws.
•With the minimum centre distance it is easy to install the belt. First put the belt on the motor pinion.
•Then put the belt around the big pulley.
•Rotate the motor several times by hand.
•Release the screw that locks the slide.
•The springs keep the belt in tension.
•Help the springs by pulling the motor slightly.
•Lock all screws.
Figure 1 shows the motor correctly wired. It is advisable to cover the wire joints between the motor and the ESC with heat
shrink tubing.
If you want to see a video of this operation, consult the SAB Heli Division YouTube channel
Motor Assembly
Motor Belt 240 GT3
( HC308-S )
Fig. 1
Page 29
Copyright@2012 – SAB Heli Division – All rights reserved