Flybarless Control Unit And Rx Installation - SAB Heli Division Goblin 700 Manual

FLYBARLESS CONTROL UNIT AND RX INSTALLATION

It is possible to install any commercially available Flybarless control unit in the goblin.
For Flybarless systems with a separate sensor, the sensor must be installed under the plate (Figure 1).
Figure 2 shows an example of installation of the receiver and flybarless control unit.
In Figure 3 you can see the extension lead for the tail servo. It is very important to include a connector for fast disassembly of
the boom module. The connector will prevent servo damage in case of boom separation during a crash.
Fig. 1
Slot for sensor cable
To install a one piece Flybarless system it is necessary to add the support shown in these figures. Figure 3 shows the installed
support. Figure 4 shows the control unit and the receiver installed on the support.
Fig. 4
Copyright@2012 – SAB Heli Division – All rights reserved
Chapter 11, Instalation of Flybarless unit and Rx
Fig. 2
It is important to lock the plugs of the flybarless
unit with an adhesive for example hot glue.
Flybarless unit
Fig. 5
RX
Flat Head Cap Screw M3x8
HC134-S
Fig. 3
Tail servo extension cable
Bag 15
Thread lock
all 6 M3 bolts
Page 27