Message Lists; Warning Messages - Sony VPL-VW1100ES Operating Instructions Manual

Symptom
ON/STANDBY flashes in
red. (A repetition rate of 5
flashes)
Note
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.

Message Lists

Warning messages

Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please replace the Lamp.
Projector temperature is
high. Cooling Setting
should be "High" if
projector is being used at
high altitude.
Cause and Remedy
c The lens protector is not fully open. Turn the power of the unit
off and then on again. If the lens protector still does not fully
open, consult with qualified Sony personnel.
Tip
In an urgent situation, refer to the illustration below to open the lens
protector with your hands. Press the
turn the power on and operate the unit.
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes
(1 page 5).
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the unit (1 page 68).
c It is time to replace the lamp. Replace the lamp (1 page 63).
c If this message appears again after you replace the lamp, the
lamp replacement process is not complete. Check the lamp
replacement process (1 page 63).
Note
To clear this message, press any button either on the remote control
or the control panel of the unit once.
c Check to ensure that the ventilation holes on the unit are not
covered (1 page 5).
c When using the unit at high altitude, set "Cooling Setting" to
"High" (1 page 40).
Note
When temperature inside the unit remains high, "Cooling Setting" is
switched to "High" in 1 minute, then the fan speed increases.
? 1
/ (ON/STANDBY) button to
61