Preset Signals - Sony VPL-VW1100ES Operating Instructions Manual

Item
Standby power
Operating temperature
Operating humidity
Storage temperature
Storage humidity
Supplied accessories
Optional accessories
Notes
• The values for mass and dimensions are approximate.
• Not all optional accessories are available in all countries and area. Please check with your local
Sony Authorized Dealer.
• Information on accessories in this manual is current as of October 2013.
Design and specifications of this unit and its optional accessories are subject to change without notice.

Preset Signals

The following table shows the signals and video formats which you can project using this
unit.
When a signal other than the preset signal shown below is input, the picture may not be
displayed properly.
Preset
memory
no.
3 480/60i
4 576/50i
5 480/60p
6 576/50p
68
Description
100V-120V AC: 3.5 W (when "Standby Mode" is set
to "Standard") / 0.3 W (when "Standby Mode" is set
to "Low")
220V-240V AC: 3.9 W (when "Standby Mode" is set
to "Standard") / 0.4 W (when "Standby Mode" is set
to "Low")
5°C to 35°C (41°F to 95°F)
35% to 85% (no condensation)
–20°C to +60°C (–4°F to +140°F)
10% to 90%
See "Checking the Supplied Accessories" in the
supplied Quick Reference Manual.
Projector Lamp: LMP-H330 (for replacement)
Projector Suspension Support: PSS-H10
3D glasses: TDG-PJ1
3D Sync Transmitter: TMR-PJ2
Preset signal
(resolution)
480/60i
(720 × 480i)
576/50i
(720 × 576i)
480/60p
(Progressive
NTSC)
(720 × 480p)
576/50p
(Progressive
PAL)
(720 × 576p)
fH fV
(kHz) (Hz)
15.734 59.940 SonG/Y
15.625 50.000 SonG/Y
31.470 60.000 SonG/Y
31.250 50.000 SonG/Y
Sync Pitch
(H Size)
–
–
–
–