Table of Contents
Advertisement
Message Lists
Warning messages
Symptom
High temp.! Light off in 1 min.
Frequency is out of range!
Projector temperature is high. High
Altitude Mode should be "On" if
Projector is being used at high
altitude.
Power Saving Mode is set. Projector
will automatically enter Standby
Mode in 1 minute.
Caution messages
Symptom
x
Not applicable!
Settings Lock enabled.
Cause and Remedy
Turn off the power.
Check to ensure that nothing is blocking the ventilation holes and the air filter is not clogged.
(page 3, 35)
Input a signal that is within the acceptable frequency range of the unit. (page 38)
Check to ensure that nothing is blocking the ventilation holes and the air filter is not clogged.
(page 3, 35)
When temperature inside the unit remains high, "High Altitude Mode" is switched to "On" in 1
minute, then the fan speed increases.
"Power Saving" is set to "Standby." (page 23)
If no signal is input, the power turns off after 1 minute, and the projector goes into standby mode.
Cause and Remedy
No signal is input in the selected input. Check connections. (page 9)
Press the appropriate button.
"Settings Lock" is set to "Level A" or "Level B." (page 25)
32
Advertisement
Table of Contents
