Sony VPL-VW1100ES Operating Instructions Manual page 34

Color Temp.
[COLOR TEMP]
Sharpness
[SHARPNESS]
Expert Setting
34
Adjusts the color temperature.
D93: Equivalent to 9,300 K color temperature normally used in TVs.
Gives white colors a blue tint.
D75: Equivalent to 7,500 K color temperature used as an ancillary
standard illuminant.
Gives a neutral tint between "D93" and "D65."
D65: Equivalent to 6,500 K color temperature used as a standard
illuminant.
Gives white colors a red tint.
DCI: DCI specification (1 page 56) color temperature.
D55: Equivalent to 5,500 K color temperature used as an ancillary
standard illuminant.
Gives white colors an even redder tint.
Custom 1 to 5: Enables you to adjust, set, and store your favorite color
temperature.
The factory default settings are as follows.
Custom 1: Same as "D93" color temperature setting.
Custom 2: Same as "D75" color temperature setting.
Custom 3: Same as "D65" color temperature setting.
Custom 4: Same as "DCI" color temperature setting.
Custom 5: Same as "D55" color temperature setting.
Sharpens the outline of the picture, or reduces the noise.
The higher the setting, the sharper the picture. The lower the setting, the
softer the picture, thus reducing the noise.
You can make adjustments by pressing the SHARPNESS +/– on the
remote control.
NR (Noise Reduction)
Reduces the roughness or noise of the picture.
Usually, use to select "Off."
If the picture is rough or noisy, select a setting from among "Low,"
"Middle" or "High" according to the input signal source.
MPEG NR (MPEG Noise Reduction)
Reduces block noise and mosquito noise, in particular in digital
signals.
Usually, use to select "Off."
If the picture is rough or noisy, select a setting from among "Low,"
"Middle" or "High" according to the input signal source.
Smooth Gradation
Smooths the gradation of the flat parts of images.
High/Middle/Low: You can adjust the smooth gradation effect.
Off: The smooth gradation function is not applied.
Film Mode
According to the film source you have selected, make a setting for
playback.
Auto 1: Suitable for reproducing the original picture movement.
Normally, set this to "Auto 1."
Auto 2: Reproduces a 2-3 or 2-2 Pull-Down format video signal, such as
film sources, in a smooth picture movement. When a video signal
other than 2-3 or 2-2 Pull-Down format is input, the picture is played
back in progressive format.
Off: Plays back the picture in progressive format without detecting
video signals automatically.