Power Saving
Lamp Setting
Sets the power saving mode.
Lamp Cutoff: If no signal is input for 10 minutes, the lamp turns off
automatically and power consumption is reduced. If signal is
resumed, or any button on the control panel or remote control is
pressed, the lamp will light again. In Lamp Cutoff, the ON/
STANDBY indicator lights in orange. (1 page 4)
Standby: If no signal is input for 10 minutes, power is turned off
automatically and the projector goes into standby mode.
Off: The power saving mode is released.
When replacing the lamps, set the desired lamp setting
(1 page 65).
41