Detector Reset Function; Setting The System Clock - GE NX-108E - Security NetworX NX-4 System User Manual

Detector reset function

This function is used to reset Smoke Detectors and Zone Troubles. Your system must be Disarmed to use the Reset
function.
Step 1 Press [r]-[7]. Resets have now been performed. The FIRE light will go off if the smoke detectors
have been reset.
Step 2 If the keypad begins beeping, the reset did not execute properly. Enter your code to silence the
keypad. Wait a few minutes and repeat step 2 to attempt another reset. If the keypad still beeps
after repeated attempts, please contact your installer.

Setting the system clock

Step 1 Enter [r][9][7].
Step 2 Enter [master code].
Step 3 Enter the "hour code" which must be two (2) digits.
Note: The clock is a 24-hour clock. Refer to the following table.
12:00 Midnight
1:00 AM
2:00 AM
3:00 AM
4:00 AM
5:00 AM
6:00 AM
7:00 AM
Step 4 Enter the "minutes code" which must be two (2) digits.
Example: 7 minutes after would be entered [0] – [7].
NX-108/116/124E User manual
Time Hour Code
00
01
02
03
04
05
06
07
Time Hour Code
8:00 AM 08
9:00 AM 09
10:00 AM 10
11:00 AM 11
12:00 Noon 12
1:00 PM 13
2:00 PM 14
3:00 PM 15
Page 15
Time Hour Code
4:00 PM 16
5:00 PM 17
6:00 PM 18
7:00 PM 19
8:00 PM 20
9:00 PM 21
10:00 PM 22
11:00 PM 23
10/11/05