Reset Function; Set System Date; Setting The System Clock - GE NX-1300E User Manual

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers. Your system must be Disarmed to use the Reset function.
Step 1 Press [ρ]-[7].
Step 2 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps
after repeated attempts, please contact your installer.

SET SYSTEM DATE

Step 1 Press the [ρ]-[9]-[6]-["Master Code"].
Step 2 Enter the "Day of Week "
1=Sunday
2=Monday
Step 3 Enter the "Month Code". Must always be two (2) digits.
01 = January
02 = February
03 = March
04 = April
Step 4 Enter the "Day Code". Must always be two (2) digits.
Example: The 5
Step 5 Enter the last two digits of the "Year Code".
Example: For 1997 enter [9]–[7].

SETTING THE SYSTEM CLOCK

Step 1 Press [ρ]-[9]-[7]-["Master Code"].
Step 2 Enter the "hour code" which must be two (2) digits. Note: The
clock is a 24-hour clock. Refer to the following table.
Step 3 Enter the "minutes code" which must be two (2) digits.
Example: 7 minutes after would be entered [0]–[7].
Resets have now been performed.
3=Tuesday
4=Wednesday
05 = May
06 = June
07 = July
08 = August
th
would be entered as [0]–[5].
Page 16
5=Thursday
6=Friday
09 = September
10 = October
11 = November
12 = December
7=Saturday