Table of Contents
Advertisement
3.3.1 Distance/black line sensor positioning
Media will advance correctly only if the sensor is correctly aligned. Manually
position the sensor, depending on the media being printed, as follows:
- For TTL...media, align the long line
marked on the sensor with the centre
of the left hand label, see fig. 9a.
- For TPM-ROLL media, align the long line
with the centre of the lateral holes to the
left of the reel, see fig. 9b.
- For KM-ROLL media, align the
short line marked on the sensor with
the centre of any label, see fig. 9c.
- Using the Print head lever, lower the print head and lock the lever.
- Close front and side covers.
- Power up the printer.
Figure 9a
Figure 9b
Figure 9c
11
Long line of the detector in the
centre of the left hand label
Stop
Long line of the detector in
the centre of the lateral holes
Stop
Short line of the detector
in the centre of any label
Stop
Sensor
TTL... media
Sensor
Holes
TPM-
media
ROLL
Sensor
KM-ROLL media
Advertisement
Table of Contents
