Battery Installation; Initializing The Remote Control; Frequency Interference - Dimplex Multifire DF3015 Parts And Service Manual

CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex North America
Limited at 1-800-668-6663 and press 4 for technical support. Please have your model and
serial number ready when calling.
REMOTE CONTROL
The remote control has a range of approximately 50 ft. (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is supplied
with 243 independent frequencies to prevent interference with other units.

BATTERY INSTALLATION

1. Depress tab on the battery cover on the back of the remote transmitter and remove
battery cover.
2. Install 2 AAA batteries into the remote control. (included)
3. Ensure child lock is in the "unlocked" position.
4. Replace the battery cover.
NOTE
When the "BAT" symbol is present on the remote control it is recommended to replace the
batteries promptly, to maintain full functionality of the remote/fireplace. The remote transmitter
has a battery backup time of only several hours.

INITIALIZING THE REMOTE CONTROL

1. Plug cord into 120 volt wall outlet.
2. Ensure the Main On/Off switch located in the switch box on the fireplace in the lower
right hand corner is in the
3. Set the 3 position manual control to the Remote position (right position).
4. Press and hold the initialization button on the unit.
5. While holding the initialization button, press the flame/heat ON/OFF
Purifire™ ON/OFF
6. Release the initialization button on the unit.
7. Press the Flame/Heat On/Off button
Purifire™ On/Off button

FREQUENCY INTERFERENCE

If the fireplace does not respond properly to the remote control, the remote operating
frequency may have to be reset. The remote control can send another frequency code to the
circuit board to eliminate interference.
1. Simultaneously press the "SLEEP TIMER DOWN" button and the "PURIFIRE LOW
SPEED" button on the remote control.
Batteries
ON position.
button on the remote control transmitter.
to turn the Purifire™ function ON.
FIGURE 3
to turn the Flame/Heat function ON or press the
3
button or the