Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7207500100R11...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS inside. Do not use in areas where ⑰ Do not strike the fireplace gasoline, paint, or flammable glass. liquids are used or stored. ⑱ Always use a certified electri- ⑭ Do not modify the fireplace. cian should new circuits or outlets Use it only as described in this be required.
Page 6
FCC CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. www.dimplex.com...
Fireplace Installation under the fireplace. Ensure that WARNING: Ensure the power both of the feet rest securely on cord is not installed so that it is this surface. pinched or against a sharp edge CAUTION: and ensure that the power cord is High temperature, stored or secured to avoid tripping risk of fire, keep electrical cords,...
Option #2: A new outlet can be sembly instructions). installed inside the new frame IMPORTANT: If not using a construction. Dimplex mantel, the fireplace NOTE: A 15 Amp, 120 Volt must be installed in an enclo- circuit is required. A dedicated sure with the following MINI-...
Operation remote control. Figure 2 • Flame (center position): The flame effect is turned on. • Flame & Heat (left position): The flame effect and heater are turned on simultaneously. When the manual control is in the Flame & Heat position the heater does not run on the remote operated thermo- stat.
“unlocked” position (Figure 3). the fireplace in the lower right hand corner is in the On 4. Replace the battery cover. position. NOTE: When the “BAT” sym- 3. Set the 3-Position Switch (Fig- bol is present on the remote www.dimplex.com...
Page 11
Operation ure 2B) to the Remote position the brightness of the upper (right position). lights. 4. Press and hold the Initializa- D. Flame Speed Control tion Button on the unit (Figure Press the button to turn the 2C). Flame & Heat on. 5.
Page 12
Press the H button to turn the lower then the A. The default tem- Purifire™ function off. perature setting is 72°F (22°C). ! NOTE: To turn the Flame & NOTE: When using the Heat and Purifire™ off, press both remote control the heater runs www.dimplex.com...
Page 13
Operation Child Lock (Figure 5) on a thermostat. Press the J or I buttons to adjust the 1. Depress tab on the battery set temperature. Once the cover on the back of the re- desired set temperature is mote and remove the battery reached the heater will turn off.
Light bulbs need to be replaced rated life. Group replacement will when you notice a dark section of reduce the number of times you the flame or when the clarity and need to open the unit to replace www.dimplex.com...
Page 15
Maintenance light bulbs. Care must be taken tab releases from the ledge when removing the log set as the located at the bottom of the log set contains LED’s and wires. mirror (Figure 7). To access the lower light bulb IMPORTANT: Only handle the area: Log Set Assembly by the Em-...
Page 16
The Purifire™ filter supplied in 1. Slide fireplace out of mantel. your fireplace is reusable and 2. Remove four Phillips screws washable. The filter should be from right side of trim (Figure cleaned or replaced on average www.dimplex.com...
Maintenance once a year. To clean the filter NOTE: If after market air filter gently tap filter on a hard sur- is used ensure it is installed face to dislodge any loose dirt or according to the manufac- debris, and then clean with water. turer’s recommended instruc- No soap or cleaning products are tions.
(a) lowing model of your newly purchased a repair or replacement warranty on defec- Dimplex electric fireplace DF3015 and to tive products or parts, including in-home newly purchased Dimplex fireplace sur- services, for the first 1 year following the rounds (mantels) and trims.
Page 19
Limited warranty service requires a proof (ii) the purchaser is solely responsible of purchase of the product. for providing clear access to all service- What Dimplex will do in the event of a able parts of the product. defect •...
Page 20
OR ITS DIRECTORS, OFFICERS, OR the first anniversary of the date of AGENTS HAVE BEEN ADVISED OF first purchase, Dimplex will in its sole THE POSSIBILITY OF SUCH LOSSES, discretion either repair or replace such COSTS OR DAMAGES, OR IF SUCH...