To Replace The Circuit Board - Dimplex Multifire DF3015 Parts And Service Manual

DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE THE CIRCUIT BOARD

1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Remove the 6 retaining screws and drill out any rivets holding the top cover to the
fireplace.
5. Lift the top cover being careful not to damage any of the wiring.
6. Disconnect all wiring clips and connectors from the circuit board noting their original
locations.
7. From inside the fireplace, break off the six mounting studs on the circuit board by
grasping with pliers and twisting on the protruding part of the stud, push the
remainder of the studs out through the top panel.
8. NOTE: New mounting studs are supplied with the replacement circuit board.
9. Properly orientate the new circuit board and connect all of the wiring connections
14