Remote Control; Battery Installation - Dimplex DFG3033 Owner's Manual

Operation
C. Initialization Button
Used to synchronize the remote
control with the fireplace.
!
NOTE: The heater on your
fireplace may emit a slight, harm-
less odor when first used. This
odor is a normal condition caused
by the initial heating of internal
heater parts and will not occur
again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset. The
temperature cutoff switch can be
reset by unplugging the unit, wait-
ing five minutes and plugging the
unit back in.
CAUTION: If you need to
continuously reset the heater,
Figure 6
Batteries
Child Lock
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539 for technical
support. Please have your
model and serial number
ready when calling.

Remote Control

The remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with 243 in-
dependent frequencies to prevent
interference with other units.

Battery Installation

1. Depress tab on the battery
cover on the back of the
remote control and remove
battery cover (Figure 6).
2. Install two AAA batteries into
the remote control (included).
3. Ensure child lock is in the "un-
locked" position (Figure 6).
4. Replace the battery cover.
!
NOTE: When the "BAT" sym-
bol is present on the remote
control it is recommended to
replace the batteries promptly,
to maintain full functionality
of the remote/fireplace. The
11