Agilent Technologies E3633A User Manual page 49

Chapter 3 Front-Panel Operation
Programming Overcurrent Protection
Over
3 Clear the overcurrent condition and exit this menu.
Current
Now, when you press
second and the
meter mode. The knob is selected for current control.
Notice that the power supply is operated in the constant current (CC) mode.
• Adjust OCP trip level
Over
1 Raise the OCP trip level.
Current
Press
Over
Current 2 Move to the OCP CLEAR mode.
OCP CLEAR
Press the key to move to the OCP CLEAR mode. The "OCP ON" message appears
on the display. Turn the knob to the right until the above message appears on the
display.
Over
3 Clear the overcurrent condition and exit this menu.
Current
Now, when you press
second and the OCP annunciator will not blink any more. The output will return to
the meter mode.
• Remote interface operation:
CURR:PROT {<current>|MIN|MAX}
CURR:PROT:STAT {OFF|ON}
CURR:PROT:CLE
36
Over
key again, the "DONE'' message is displayed for a
Current
annunciator will not blink any more. The output will return to
OCP
Over
key and turn the knob to raise the OCP trip level.
Current
Over
key again, the "DONE'' message is displayed for a
Current
Set the OCP level
Disable or enable the OCP circuit
Clear the tripped OCP circuit