Agilent Technologies E3633A User Manual page 42

Chapter 3 Front-Panel Operation
Storing and Recalling Operating States
Store
4 Save the operating state.
The operating state is now stored. To recall the stored state, go to the following steps.
DONE
Recall
5 Turn on the recall mode.
Memory location "1" will be displayed in the recall mode.
RECALL 1
This message appears on the display for approximately 3 seconds.
6 Recall the stored operating state.
Turn the knob to the right to change the displayed storage location to 3.
RECALL 3
If this setting is not followed within 3 seconds with
supply returns to normal operating mode and will not recall the instrument state 3
from memory.
Recall
7 Restore the operating state.
The power supply should now be configured in the same state as when you stored the
state on the previous steps.
DONE
This message appears on the display for approximately 1 second.
• Remote interface operation:
*SAV {1|2|3}
*RCL {1|2|3}
Store an operating state to a specified location
Recall a previously stored state from a specified location
Recall
key stroke, the power
3
29