NEC Aspire Product Description page 145

Federal Communications Commission DID Requirements
This equipment must operate in a manner that is not in violation of Part 68 rules. This equipment
returns answer supervision to the Public Switched Network when the DID trunk is: (1) answered by the
called station; (2) answered by the attendant; (3) routed to a recorded announcement that can be admin-
istered by the CPE user; (4) routed to a dial prompt.
The equipment returns answer supervision on all DID calls forwarded back to the Public Switched
Telephone Network except when: (1) a call is unanswered; (2) a busy tone is received; (3) a reorder
tone is received.
When ordering DID Service, provide the telco with the following information:
FCC Registration Number:
DID Facility Interface Code:
DID Service Order Code:
DID Answer Supervision Code
DID USOC Jack Type:
Please note the following:
1. DID services must be purchased from the local telephone company.
2. Refer to the Software Manual for detailed DID description, conditions, and programming
instructions.
1. Do not run station cable in parallel with the AC source, telex or computer, etc. If the cables are
near cable runs to those devices, use shielded cable with grounded shields or install the cable in
conduit.
2.When cables must be run on the floor, use cable protectors.
3. Cable runs for key telephones, single line telephones, Door Boxes, CTA or CTU adapters, and
2PGDAD Modules must be a dedicated, isolated cable pair.
4. The Telco RJ21X and cross-connect blocks should install to the right of the Main Cabinet.
Extension blocks and cross-connect blocks should be installed to the left of the Main Cabinet.
Product Description
Section 4: Specifications and Parts List
FCC DID Requirements
TBD
02RV2-T
9.0F
A S.2
RJ21X
Cabling Requirements
4
139