Compressor; Condenser - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Component Access / Removal

Compressor

NOTE: Always replace the high-side filter-drier when
servicing the sealed system.
NOTE: Due to the limited access under the 315W, it
will be necessary to separate the cabinet case from the
unit base to access components in the compressor
area.
The compressor is located at the back of the unit base.
To access the compressor, the unit will need to be
pulled from its installation.
With unit out of installation and case separated from
unit base (See Figures 5-16):
1. Disconnect compressor electricals.
2. With a tube-cutter, cut suction tube and discharge
tube approximately 1-1/2" from compressor.
3. Remove cotter pins and washers from compressor
mounting brackets, then lift compressor off of
mounting brackets.

Condenser

NOTE: Always replace the high-side filter-drier when
servicing the sealed system.
NOTE: Due to the limited access under the 315W, it
will be necessary to separate the cabinet case from the
unit base to access components in the compressor
area.
The condenser is located on the left side of the unit
base, and is held in place with screws passing up from
under unit base into the condenser mounting brackets.
To access the condenser, the unit will need to be pulled
from its installation, and the cabinet case separated
from the unit base, then, (See Figure 5-17):
1. With a tube-cutter, cut inlet tube and outlet tube
approximately 3" from the condenser.
2. Extract condenser mounting screws from unit base
and from side brackets.
3. Extract screws securing the condenser fan shroud
to the condenser and remove fan shroud.
#3758664 - First Edition - July, 2005
Model 315W
Wine Storage
Unit Base
Figure 5-16. Unit Tray Component Access
Condenser
Fan Shroud
Condenser
Figure 5-17. Condenser Removal
5-10
Compressor
Hitch Pin and
Washer
Mounting
Grommet
Bracket
Cut
Here
Extract
Screws