Power Cord; Separating Cabinet Case From Unit Base - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Wine Storage

Power Cord

NOTE: Electrical shock hazard, take note of WARN-
INGS and CAUTIONS on page 5-2.
The power cord is located at the right rear of the unit.
To access the power cord, the unit will need to be
moved out from its installation position. The back cover
and insulation pack must be removed first, then, (See
Figure 5-6):
1. With a flat bladed screwdriver remove electrical
cover from rear of unit.
2. Disconnect wire leads.
3. Remove power cord strain relief from cabinet case
and extract cord from unit.

Separating Cabinet Case from Unit Base

In order to access components located in the compres-
sor area, the cabinet case must be separated from the
unit base.
NOTE: The cabinet case cannot be completely sepa-
rated from the unit base unless the heat exchanger is
severed.
To separate cabinet case from unit base (See Figure 5-
7):
1. Remove door assembly, wine racks, and back
cover with the insulation pack.
NOTE: Removal of the door and wine racks is rec-
ommended for safety and for weight reduction
when lifting and separating the cabinet.
2. Extract screws from bottom sides of cabinet case.
3. The cabinet case may be separated two ways.
a. For servicing the light switch, thermostat, or
drain pan, it may only be necessary to use a
spacer (a piece of 2x4 lumber works well) to lift
the front of the cabinet case enough to allow
access.
b. For servicing the sealed system, the case may
be removed from the unit base by carefully lift-
ing the cabinet case above the sealed system
components mounted to the unit base, and
turning the case to the right.
When lifting and turning the cabinet case, be
mindful of the sealed system components so
they are not crimped or damaged.
Model 315W
Remove Electrical
Cover
5-5
Component Access / Removal
Cabinet Case
Figure 5-6 Power Cord Removal
Cabinet Case
Remove Screws
Figure 5-7. Cabinet Case Removal
#3758664 - First Edition - July, 2005
Insulation
Pack
Back
Cover
Baffle