Light Switch And Plunger Switch; Thermostat - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Component Access / Removal

Light Switch and Plunger Switch

NOTE: Electrical shock hazard, take note of WARN-
INGS and CAUTIONS on page 5-2.
The switches are inserted into a bracket located behind
the kickplate at the bottom front of unit.
To remove the light switch or plunger switch, the unit
must be pulled from its installation and the kickplate
must be removed first, then (See Figure 5-8):
1. From the bottom of the appliance, extract the
screws that secure the bracket and pull the bracket
forward.
2. Disconnect wire leads from switch.
3. Depress retaining clips at sides of switch and push
switch out through mounting bracket.

Thermostat

NOTE: Electrical shock hazard, take note of WARN-
INGS and CAUTIONS on page 5-2.
The thermostat is attached to a bracket located behind
the kickplate at the bottom front of unit. The thermostat
bulb runs to the rear of the unit, up the back and into
the refrigerated compartment. The coiled end of the
thermostat bulb is attached to the bottom rear of the
evaporator plate with a bracket and screws.
To remove the thermostat, the unit must first be pulled
from its installation, and the back cabinet cover, as well
as the kickplate must be removed, then (See Figure 5-
8):
1. From inside unit:
a. Extract screws securing the thermostat bracket
to bottom rear of the evaporator.
b. Pull coiled end of thermostat bulb from the
compartment.
2. At bottom of unit:
a. Extract the screws that secure the bracket to
the base and pull bracket forward.
b. Disconnect wire leads from thermostat and pull
thermostat bulb toward front of unit.
#3758664 - First Edition - July, 2005
Model 315W
Wine Storage
Bracket
Rocker
Switch
Figure 5-8. Light Switch, Plunger Switch and
Thermostat Removal
5-6
Thermostat
Plunger
Switch