Exterior Cosmetic And Mechanical Components; Kickplate; Door Gasket And Door Handle; Door And Door Hinge - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Wine Storage
EXTERIOR COSMETIC AND MECHANICAL
COMPONENTS

Kickplate

The kickplate, located under the door assembly, is vent-
ed to allow air flow through the compressor area.
To remove the kickplate (See Figure 5-1):
1. Open door.
2. Pull temperature control knob from thermostat
shaft.
3. Extract the mounting screws from each end of kick-
plate and pull kickplate forward.

Door Gasket and Door Handle

The door gasket is held in place by pressing the spline
of the gasket into a channel in the door assembly.
The door handle is secured to the door with screws that
pass through the door assembly and standoffs, into the
handle. The heads of thee screws are hidden in the
gasket channel, covered by the gasket.
To remove a gasket and/or handle (See Figure 5-2):
1. Open door.
2. Pull door gasket from channel of door.
3. Extract the door handle mounting screws and pull
the handle and standoffs from the door.

Door and Door Hinge

To remove the door and hinges (See Figure 5-3):
1. Open door so door hinge mounting screws are visi-
ble.
2. Extract bottom door hinge mounting screws.
3. While holding door assembly, extract top door hinge
mounting screws.
4. Remove door assembly from unit.
NOTE: When removing the door, be aware of the
spacer bushings between the hinge and door
assembly so they are not lost.
5. Remove the cabinet hinges by extract the screws
securing the hinges to the unit frame.
NOTE: Depending on unit installation, it may be
necessary to extract unit from its installed position
to access the cabinet hinge screws.
Model 315W
Door Handle
5-3
Component Access / Removal
Figure 5-1. Kickplate Removal
Figure 5-2. Door Handle and Gasket Removal
Figure 5-3. Door and Hinge Removal
#3758664 - First Edition - July, 2005