Model 315W Specifications ..... 4 highlighted information throughout this guide: Model 315W Installation ..... . . 6 IMPORTANT NOTE highlights information that is especially Installation Checklist .
The homeowner should keep this installation guide for future reference. Any questions or problems regarding the installation should be directed to your authorized Sub-Zero dealer or Location of rating plate. Sub-Zero customer care at 800-222-7820. You may also check the contact &...
Model 315W Specifications Model 315W Specifications OVERALL DIMENSIONS INSTALLATION " 24" (384) (610) TOP VIEW 24" (610) OPENING DEPTH " (865) 4" (102) 24" " " (610) (876) OPENING DEPTH OPENING (387) OPENING HEIGHT WIDTH " (422) SIDE VIEW FRONT VIEW "...
Page 5
Area Requirements Electrical Requirements Before moving the unit into place, make sure the opening Model 315W must be installed with adequate clearance dimensions, door clearance and electrical service are for electrical connection at the rear of the unit. The elec- correct.
An anti-tip bracket and hardware is provided with model Use an appliance dolly to move the wine storage unit near 315W. Placement of the anti-tip bracket is critical to a the installation opening. Position the dolly at the side of stable installation.
Page 7
Slide the wine storage unit back into position in the Shut off power to the electrical outlet. installation opening. IMPORTANT NOTE: Model 315W has been designed to be serviced in place, but in some cases it may be necessary LEVEL THE UNIT to pull the unit out for service.
Page 8
KICKPLATE AIRFLOW Additional panel information can be found in the wine Model 315W uses a fan to take in room air through vents storage section of the Sub-Zero design guide, or check in the left side of the kickplate, and discharges warm air our website at subzero.com.
Page 9
This is to accommodate holes should be marked. If not, only enough holes to hold Sub-Zero accessory handles and provide for easy attach- the panel in place temporarily, are necessary. ment of the handle through the door frame.
To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure The model 315W glass door is made with a sealed, that no part of the installation has been overlooked. double-wall tempered glass core. The drill must not contact this core when drilling.
Need help?
Do you have a question about the 315W and is the answer not in the manual?
Questions and answers