Wine Rack; Cabinet Slide And Spacer; Light Bulb And Light Housing - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Wine Storage
INTERNAL COMPONENTS
Wine Racks
To remove a wine rack assembly (See Figure 5-9):
1. Pull rack forward until it stops.
2. Lift front of rack up while pulling forward.
3. After indentations on the wine rack clear the rollers
on the cabinet slides, lower front of rack while con-
tinuing to pull forward and lifting rear of rack.

Cabinet Slide and Spacer

Cabinet slides are attached to the side walls with
screws. On the handle side, a narrow plastic spacer sits
between the slide and side wall. On the hinge side, a
wide plastic support spacer sits between the slide and
wall.
To remove a cabinet slide, the wine rack must be
removed first, then extract the Phillips head mounting
screws and pull the slide and slide spacer from the wall.
(See Figure 5-10)

Light Bulb and Light Housing

The light bulb is located at the inside top of the appli-
ance and is protected by the light housing.
NOTE: Electrical shock hazard, take note of WARN-
INGS and CAUTIONS on page 5-2.
To remove the light bulb and light housing. (See Figure
5-11)
1. Remove top wine rack.
2. Pull electrical plug from socket at top of the com-
partment.
3. Remove the bulb from holder.
4. If bulb housing needs to be replaced, extract
screws securing bulb housing to the top of the com-
partment.
Model 315W
5-7
Component Access / Removal
Figure 5-9. Wine Rack Assembly Removal
Extract
Screws
Spacer
Figure 5-10. Slide and Spacer Removal
Extract Screws
Figure 5-11 . Light Bulb and Housing Removal
#3758664 - First Edition - July, 2005